Keywords
Adhesión; Resina bulk-fill; Lámpara de fotocurado; Reparación de resina, MEB.
How to Cite
Abstract
The aim of this study was to evaluate and compare the effects of different light sources on shear bond strength when bulk-fill composite was used for the repair of different composite resins. A total of 126 samples made from six resin composites with different properties were aged (thermal-cycling with 5000 cycle), exposed to the same surface treatments and adhesive procedure. Then, they were repaired with a bulk-fill composite. At the polymerization step, each group was divided into three subgroups (n=7) and light cured with a QTH light source for 40s and two different LED light sources for 20s. Subsequently, the specimens were aged in distilled water at 37 ºC for 4 weeks and then subjected to shear bond strength test. Then, the specimens were examined under a stereomicroscope to identify modes of failure and visualized by Scanning Electron Microscope. Data obtained from the study were analyzed using ANOVA and Tukey HSD Test (α=0.05). In all groups, the light curing units had an impact on shear bond strength (p<0.05). Among the study groups, the greatest bond strength values were observed in the specimens repaired using the LED and the specimens repaired with the QTH light curing unit had the lowest bond strength values. It was concluded that the content of composite resins and light curing units may influence bond strength of different composites repaired with the bulk-fill composite.
References
Hickel R., Manhart J.. Longevity of restorations in posterior teeth and reasons for failure. J Adhes Dent. 2001; 3 (1): 45-64.
Tyas M.J., Anusavice K.J., Frencken J.E., Mount G.J. Minimal intervention dentistry--a review. FDI Commission Project 1-97. Int Dent J. 2000; 50 (1): 1-12.
Opdam N.J., van de Sande F.H., Bronkhorst E., Cenci M.S., Bottenberg P., Pallesen U., Gaengler P., Lindberg A., Huysmans M.C., van Dijken J.W.
Longevity of posterior composite restorations: a systematic review and meta-analysis. J Dent Res. 2014; 93 (10): 943-949.
Blum I.R., Schriever A., Heidemann D., Mjor I.A., Wilson N.H. The repair of direct composite restorations: an international survey of the teaching of operative techniques and materials. Eur J Dent Educ. 2003; 7 (1): 41-48.
Fernandez E., Martin J., Vildosola P., Oliveira Junior O.B., Gordan V., Mjor I., Bersezio C., Estay J., de Andrade M.F., Moncada G. Can repair increase the longevity of composite resins? Results of a 10-year clinical trial. J Dent. 2015; 43 (2): 279-286.
Spyrou M., Koliniotou-Koumpia E., Kouros P., Koulaouzidou E., Dionysopoulos P. The reparability of contemporary composite resins. Eur J. Dent. 2014; 8 (3): 353-359.
Park J., Chang J., Ferracane J., Lee I.B. How should composite be layered to reduce shrinkage stress: incremental or bulk filling? Dent Mater. 2008; 24 (11): 1501-1505.
Benetti A.R., Havndrup-Pedersen C., Honoré D., Pedersen M.K., Pallesen U. Bulk-fill resin composites: polymerization contraction, depth of cure, and gap formation. Oper Dent. 2015; 40 (2): 190-200.
Par M., Gamulin O., Marovic D., Klaric E., Tarle Z. Raman spectroscopic assessment of degree of conversion of bulk-fill resin composites–changes at 24 hours post cure. Oper Dent. 2015; 40 (3): E92-E101.
Atalay C., Yazici A.R., Ozgunaltay G. Bond strengths of bulk-fill resin composite repairs: effect of different surface treatment protocols in vitro. J Adhes Sci Technol. 2018; 32 (9): 921-930.
Koç-Vural U., Kerimova L., Baltacioglu İ.H., Kiremitçi A. Bond strength of dental nanocomposites repaired with a bulkfill composite. J Clin Exp Dent. 2017; 9 (3): 437-442.
Kopperud H.M., Johnsen G.F., Lamolle S., Kleven I.S., Wellendorf H., Haugen H.J. Effect of short LED lamp exposure on wear resistance, residual monomer and degree of conversion for Filtek Z250 and Tetric EvoCeram composites. Dent Mater. 2013; 29 (8): 824-834.
Jandt K.D., Mills R.W., Blackwell G.B., Ashworth S.H. Depth of cure and compressive strength of dental composites cured with blue light emitting diodes (LEDs). Dent Mater. 2000; 16 (1): 41-47.
Brendeke J., Özcan M. Effect of physicochemical aging conditions on the composite-composite repair bond strength. J Adhes Dent. 2007; 9 (4): 399-406.
Hisamatsu N., Atsuta M., Matsumura H. Effect of silane primers and unfilled resin bonding agents on repair bond strength of a prosthodontic microfilled composite. J. Oral Rehabil. 2002; 29 (7): 644-648.
Özcan M., Barbosa S.H., Melo R.M., Galhano G.A.P., Bottino M.A. Effect of surface conditioning methods on the microtensile bond strength of resin composite to composite after aging conditions. Dent Mater. 2007; 23 (10): 1276-1282.
Özcan M., Cura C., Brendeke J. Effect of aging conditions on the repair bond strength of a microhybrid and a nanohybrid resin composite. J Adhes Dent. 2010; 12 (6): 551-557.
Rode K., Kawano Y., Turbino M. Evaluation of curing light distance on resin composite microhardness and polymerization. Oper Dent. 2007; 32 (6): 571-578.
D Alpino P.H., Wang L., Rueggeberg F.A., Svizero N.R., Pereira J.C., Pashley D.H., Carvalho R.M. Bond strength of resin-based restorations polymerized with different light-curing sources. J Adhes Dent. 2006; 8 (5): 293-298.
Amaral C.M., Peris A.R., Ambrosano G.M.B., Swift E., Pimenta L.A.F. The effect of light-curing source and mode on microtensile bond strength to bovine dentin. J Adhes Dent. 2006; 8 (1): 41-45.
Khosla M., Malhotra N., Mala K. An in vitro evaluation of shear bond strength of silorane and bis-GMA resin-based composite using different curing units. J Conserv Dent 2012; 15 (3): 278-82.
Karaman E., GÖNÜLOL N. Does the light source affect the repairability of composite resins? Braz Oral Res. 2014; 28 (1): 1-6.
Kim J.S., Choi Y.H., Cho B.H., Son H.H., Lee I.B., Um C.M., Kim C.K. Effect of light-cure time of adhesive resin on the thickness of the oxygen-inhibited layer and the microtensile bond strength to dentin. J Biomed Mater Res B Appl Biomater 2006; 78: 115-123.
Dickens S.H., Cho B.H. Interpretation of bond failure through conversion and residual solvent measurements and Weibull analyses of flexural and microtensile bond strengths of bonding agents. Dent Mater. 2005; 21 (4): 354-364.
Uhl A., Sigusch B.W., Jandt K.D. Second generation LEDs for the polymerization of oral biomaterials. Dent Mater. 2004; 20 (1): 80-87.
Bala O., Ölmez A., Kalayci Ş. Effect of LED and halogen light curing on polymerization of resin-based composites. J. Oral Rehabil. 2005; 32 (2): 134-140.
Shimokawa C., Sullivan B., Turbino M., Soares C., Price R. Influence of Emission Spectrum and Irradiance on Light Curing of Resin-Based Composites. Oper Dent. 2017; 42 (5): 537-547.
Wayne R.P. Photochemistry: Butterworths; 1970.
Lucey SM, Santini A, Roebuck EM. Degree of conversion of resin-based materials cured with dual-peak or single-peak LED light-curing units. Int J Paediatr Dent. 2015; 25 (2): 93-102.
Shimokawa C.A.K., Turbino M.L., Giannini M., Braga R.R., Price R.B. Effect of light curing units on the polymerization of bulk fill resin-based composites. Dent Mater. 2018.
Menees T.S., Lin C.P., Kojic D.D., Burgess J.O., Lawson N.C. Depth of cure of bulk fill composites with monowave and polywave curing lights. Am J Dent. 2015; 28 (6): 357-361.
Lima A.C., Rached-Junior F.J., Faria N.S., Messias D.C., Chaves Cde A., Freitas J.V., Baratto-Filho F., Silva-Sousa Y.T. Influence of Sealer and Light-Curing Units on Push-Out Bond Strength Of Composite Resin to Weakened Roots. Braz Dent J. 2016; 27 (4): 430-435.
de Jesus Tavarez R.R., Júnior LJdSA, Guará T.C.G., Ribeiro I.S., Maia Filho E.M., Firoozmand L.M. Shear bond strength of different surface treatments in bulk fill, microhybrid, and nanoparticle repair resins. Clin Cosmet Investig Dent. 2017; 9: 61.
Sideridou I., Tserki V., Papanastasiou G. Study of water sorption, solubility and modulus of elasticity of light-cured dimethacrylate-based dental resins. Biomaterials. 2003; 24 (4): 655-665.
Oilo G. Bond strength testing--what does it mean? Int Dent J. 1993; 43 (5): 492-498.
Baur V., Ilie N. Repair of dental resin-based composites. Clin Oral Invest. 2013; 17 (2): 601-608.
Teixeira E. C., Bayne S. C., Thompson J. Y., Ritter A. V., Swift E. J. Shear bond strength of self-etching bonding systems in combination with various composites used for repairing aged composites. J Adhes Dent. 2005; 7 (2): 159-164.
Tabatabaei M.H., Alizade Y., Taalim S. Effect of various surface treatment on repair strength of composite resin. J Dent (Tehran). 2004; 1 (4): 5-11.
Cavalcanti A.N., De Lima A.F., Peris A.R., Mitsui F.H.O., Marchi G.M. Effect of surface treatments and bonding agents on the bond strength of repaired composites. J Esthet Restor Dent 2007; 19: 90-8.